PTFE Tube Tolerances: What Engineering Buyers Need to Confirm

Short answer: For PTFE tube, engineering buyers should confirm four tolerance groups before ordering: OD and ID (usually ±0.05–0.1 mm on precision grades), wall thickness concentricity (the hidden variable that affects pressure rating), length (±1 mm is standard; tighter costs more), and — for tubing destined for fittings — ovality. PTFE’s thermal expansion means every tolerance is only meaningful at a stated temperature.

Tube tolerances are where PTFE differs most from metal sourcing. The material is dimensionally “soft” in every sense: it moves with temperature, deforms under handling, and can relax after cutting.

The Four Tolerance Groups

  1. OD/ID: standard commercial tubing runs wider bands; precision tube holds ±0.05 mm. State which positions are fitting-sealing surfaces — those need the tight band, the rest doesn’t.
  2. Concentricity/wall: the underrated one. A tube at nominal wall but off-center has a thin side that governs burst pressure. For pressure duties, ask for minimum wall, not nominal.
  3. Longitud: ±1 mm on cut lengths is routine. Autoclave or fixture-critical lengths justify ±0.2 mm at modest premium.
  4. Ovality: compression fittings seal on round tube. Shipping coils flattened tube; specify straight or supported packaging for fitting-duty tube.

Temperature: The Fine Print That Isn’t Fine

FactorPractical effect
Thermal expansion (~10× steel)A tube at ±0.05 mm at 20 °C is out of band near 60 °C
Post-cut relaxationCut ends can deform; squareness needs bore support

Always ask at what temperature the supplier’s tolerance applies, and measure incoming parts at controlled temperature if you’ll verify against it.

RFQ Wording That Works

“PTFE tube, OD 12.7 mm +0.05/−0.05, ID 9.5 mm ±0.1, minimum wall 1.4 mm, cut length 500 ±0.5 mm, tolerances valid at 23 °C, straight packaging.” One sentence; zero assumption gaps. Chunhuan supplies precision PTFE tubing to stated tolerances with temperature-referenced measurement records.

Frequently Asked Questions

What tolerances can precision PTFE tubing hold?

OD/ID at ±0.05 mm is achievable on precision grades; commercial tubing runs wider. Cut lengths hold ±1 mm standard, ±0.2 mm at premium.

Why is wall concentricity important for PTFE tube?

An off-center wall means one thin side governs burst pressure. For pressure duties, specify minimum wall rather than nominal.

At what temperature are PTFE tube tolerances valid?

Whatever the supplier states — typically 23 °C. PTFE’s thermal expansion is roughly 10× steel, so tolerances drift with temperature.

How should tube for compression fittings be specified?

Tight OD tolerance plus ovality control and straight/supported packaging — fittings seal on round, undistorted tube.

Facebook
Gorjeo
LinkedIn
WhatsApp

Deja una respuesta

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *

Envíe su consulta hoy